Airlink APSUSB2 Manuel d'utilisateur

Installation GuideModel # APSUSB2

Step 12 Type in the IP address of thePrint Server and the port name you havewritten down on the piece of paper in Sec-tion 3 and click OK. See Fig. 4.

Step 21Select the manufacturer and modelof your printer and click Next.Note: If your printer is not on the list, clickHave Disk, insert the printer dr

Section 5Using the Web Configuration UtilityYou can use the Web Configuration Utility to configure the settings for your PrintServer. There are four s

ConfigurationServer Device: Configures the PrintServer properties. See Fig. 5.3Server Name: Assign a name to the PrintServer or keep the default.Locat

NetBEUI Protocol: Configures the set-tings for NetBEUI printing. See Fig. 5.5Fig. 5.5AppleTalk Protocol: Configures the set-tings for AppleTalk printi

Reset: Restart the Print Server. Click Yesto restart the Print Server. See Fig. 5.7Fig. 5.7Factory Reset: Reset all settings to fac-tory default and r

Section 6Product SpecificationsPrinter ConnectionPrinter Interface: One USB Port (ver 1.1), Two 25-pin parallel portsNetwork ConnectionNetwork Interfa

Section 7Technical SupportE-mail: [email protected] Free: 1-888-746-3238Web site: www.airlinkplus.com

Step 1Connect one end of the Ethernet cable to the RJ-45 port of the Print Serverand attach the other end of the cable to a hub/switch/router. See Fig

Section 2Configuring Client IP AddressNote: The default IP address of the Print Server is 192.168.1.254 with a subnet maskof 255.255.255.0 The Print S

For Windows 95/98/MEStep 1 Go to Start, Settings, ControlPanel, and double-click the Network icon.Step 2 Select TCP/IP and clickProperties. See Fig. 2

Section 3Accessing the Web Configuration UtilityStep 1 Open the web browser and type thedefault IP address of the Print Server: 192.168.1.254 See Fig.

Step 5 Click on TCP/IP Protocol underConfiguration. See Fig. 3.4Step 6 You can manually assign an IP ad-dress and subnet mask to allow the PrintServer

Step 4 Select Create a new port. At thedrop-down menu, select Standard TCP/IPPort and click Next. See Fig. 4.2Step 5 Click Next at the Add StandardTCP

Step 8 Select LPR for the Protocol, enterthe Port Name in the Queue Name field,and click OK. See Fig. 4.5Step 9 Click Next.Step 10 Click Finish.Fig. 4

For Windows 95/98/MEStep 1 Go to Start, Settings, ControlPanel, and double-click on Network.Step 2 Click Add.Step 3 Select Client and click Add. SeeFi